Difference between revisions of "TinkerAccess"
m |
|||
| Line 8: | Line 8: | ||
FAQs: | FAQs: | ||
| + | |||
Q: What Should I do if TinkerAccess locks up? | Q: What Should I do if TinkerAccess locks up? | ||
| − | A: TinkerAccess is typically | + | |
| + | A: TinkerAccess power is typically tied to the machine power. To reset TinkerAccess, turn off the machine and unplug the machine from power. Wait 5-10 seconds, and then plug the machine back in. | ||
| + | |||
Q: What if someone badges over me during my session? | Q: What if someone badges over me during my session? | ||
| + | |||
A: If you someone badges over you during your session they will simply replace you as the user being recorded. It will not interrupt the machine power/operation. | A: If you someone badges over you during your session they will simply replace you as the user being recorded. It will not interrupt the machine power/operation. | ||
| + | |||
Q: I have taken the class but am not in the system. | Q: I have taken the class but am not in the system. | ||
| + | |||
A: Contact the instructor to have them manually add you. | A: Contact the instructor to have them manually add you. | ||
| + | |||
If there are any other questions, feel free to reach out to Matt Stallard on Slack or via email: @matt.stallard or matthew.stallard@tinkermill.org | If there are any other questions, feel free to reach out to Matt Stallard on Slack or via email: @matt.stallard or matthew.stallard@tinkermill.org | ||
Revision as of 19:52, 16 September 2016
TinkerAccess is and RFID Access Control System that was developed and built at TinkerMill. The main purpose of TinkerAccess is to prevent unauthorized users from using the machine as well as helping keep track of who is using the machine and when.
How to Use:
- Scan RFID fob over scanner area. Access will either be granted or denied.
- The timer can be reset without interruption to the machine by re-scanning your RFID fob.
- To log off, press the log off button on the side of the enclosure. This will end your session.
FAQs:
Q: What Should I do if TinkerAccess locks up?
A: TinkerAccess power is typically tied to the machine power. To reset TinkerAccess, turn off the machine and unplug the machine from power. Wait 5-10 seconds, and then plug the machine back in.
Q: What if someone badges over me during my session?
A: If you someone badges over you during your session they will simply replace you as the user being recorded. It will not interrupt the machine power/operation.
Q: I have taken the class but am not in the system.
A: Contact the instructor to have them manually add you.
If there are any other questions, feel free to reach out to Matt Stallard on Slack or via email: @matt.stallard or matthew.stallard@tinkermill.org
